Advertisement
Home LIFESTYLE

How to make a homemade mouse trap using a bucket

For when single mouse traps just won't cut it.
Loading the player...

If you’re currently dealing with a mouse infestation, or living through a mouse plague – you may be looking for a way to get rid of the pests without resorting to baits and poisons.

Advertisement

When rodent numbers are out of control, store bought traps (which can only catch one mouse at a time), just won’t cut it. That’s where a homemade mouse trap can come in handy.

WATCH: Adam Dovile demonstrates ways to control mice and rats

Mice are an invasive species that can wreak havoc across ecosystems. Regions where grain is produced and stored can be particularly vulnerable to rapid increases in mice populations.

According to research by CSIRO, one of the worst mice plagues on record in 2010/2011 caused $96 million worth of damage. Mice ate crops, attacked livestock, chewed through rubber and insulation which destroyed vehicles, farm machinery and buildings. That’s all without mentioning the knock-on impact of mouse plagues on mental health.

Advertisement

While there’s no quick way to deal with a mouse infestation, reducing the numbers in and around your home can provide some peace of mind. This DIY mouse trap is cheap to make and can capture a large number of mice at any one time.

Trap pest data while you’re at it

You can help researches monitor invasive species, target pest control programs and predict future plagues by downloading the FeralScan Pest Mapping app

Gather your supplies

  • Drill
  • 20L bucket with handle 
  • Empty soft drink can
  • 50cm length of metal wire
  • 1 Tbsp vegetable oil
  • Paper towel
  • Peanut butter
  • Plank of wood

Here’s how

Step 1

Using a drill, make a hole about 3cm down from the opening of the bucket. Repeat on the opposite side.

Advertisement

Step 2

Drill a hole into the bottom of the soft drink can and feed the wire through the can. Feed each end of the wire through the holes in the plastic bucket and secure. The soft drink can should be suspended over the bucket in the middle of the wire. Adjust until the can spins freely on the wire.

Step 3

Using a paper towel, spread vegetable oil around the inside of the bucket. This will help to prevent mice crawling out of the trap. Add 2-3 litres of water to the bucket.

Step 4

Coat the soft drink can in a generous layer of peanut butter and lean a plank of wood against the bucket. The plank of wood will act as a runway for the mice to reach the peanut butter and fall into the trap.

Advertisement

TIP: If using this trap indoors, leave to work overnight. If using it in a shed or an outdoor area during a mouse plague, you may need to check on the trap every few hours, as it won’t take long to start working.

For instructions on how to dispose of dead mice correctly, contact your local council. Mice can carry diseases, so be sure to wear adequate protective clothing when handling and disposing of mice. For more information on how to control mice and rats humanely, visit RSPCA

Advertisement

Related stories


Advertisement