Step 2 Spread road base inside marked lines to depth of 80mm. If there’s a slight slope, use road base to build up areas so site is level (include a fall to allow for rainwater run-off). Wet and compact down to 70mm.
Step 3 Spread 30mm of bedding sand over areas to be paved. Lay screed rails and, using a straightedge and spirit level, steadily drag straightedge along rails, screeding off and packing sand to create a firm, level laying surface. Remove screed rails.
Step 4 Hammer in pegs in corners of paving area. Run stringline between pegs and set to finished height of pavers. Starting in 1 corner, lay pavers along stringline. Gently tap into place with rubber mallet and check level.
Step 5 Pave whole area, leaving spacers (at least 180mm wide) in paving pattern where Ekodeck decking will feature. Once all pavers are in place, return to install decking.
Step 6 Using brickie’s trowel, excavate excess sand from channels so that pine sleeper (to be fixed beneath Ekodeck decking) sits 23mm below pavers.
Step 7 Position decking on top of sleeper. Fix decking to sleeper using a screw on each side of plank to prevent warping. Fix at each paving join using countersunk screws.