Bhg
  • Shop
  • News
  • Food
  • DIY
  • Garden
  • Renovating
  • Decorating
  • Health
  • TV
  • Hard to Find
Bhg
  • Shop
  • News
  • Food
  • DIY
  • Garden
  • Renovating
  • Decorating
  • Health
  • TV
  • Hard to Find
Subscribe
  1. Home
  2. DIY

How to make DIY plantholder

Showcase your favourite potted plant with a handcrafted stand. - by Natasha Dickins
  • 28 Sep 2018

This one is 400mm high and 235mm wide, designed for a 190mm-wide pot

pot

What you need:

TIMBER

  • Porta 30 x 18mm 3m Tasmanian Oak DAR Moulding

 MATERIALS

  • Zenith 8-10 x 40mm Galvanised Countersunk Ribbed Head Timber Screws 20 Pack
  • Parfix 250ml PVA Wood Glue
  • Paint Partner 15-piece Sandpaper Set
  • Pinnacle 9.5mm Pine Screw Caps 10-Pack
  • Bondall 300g Natural Monocel Furniture Oil Trigger Pack

 TOOLS

  • Craftright 12-Piece Carpenters Pencil With Sharpener
  • Craftright 3m Tape Measure
  • Empire 150mm True Blue Combination Square
  • 2 x Craftright 80 x 300mm F Clamp
  • Trojan 25mm Wood Chisel
  • Trojan 160z Claw Wood Hammer
  • Craftright Mitre Box And Saw Set
  • Ryobi 130-piece Drilling and Driving Set
  • Ryobi 19 Piece Metric High Speed Steel Drill Bit Set
  • P&N 4 Piece Quickbit Pilot Drill / Countersink Bit Set

 THE POT

  • Scheurich 19 x 17cm White Panna Glazed Round Indoor Pot

HOW-TO STEPS:

  1. From the Tasmanian oak, cut four legs to 400mm long and two rails to 195mm, which is just little wider than the base of our pot. TIP Adjust the length of the rails to suit your pot.
  2. On one rail, mark halfway along, on the other rail, mark halfway across. Put them together to transfer the width of the cross-halving joint, which is the recess to be chiseled.
  3. Use a combination square to mark the width across both rails and down the sides, then mark halfway up the side of the rails to indicate the depth of the joint.
  4. Use two clamps to secure the rail on a solid surface.
  5. Use a sharp chisel with a hammer to tap along the lines of the joint. TIP Keep the flat side of the chisel facing outwards.
  6. Chisel out the joint, working from one side, flipping the rail to work from the other and repeating as necessary. Repeat with the other rail. TIP Keep the bevelled side of the chisel facing down to use the angle to cut along the timber.
  7. Check the pieces fit snugly and are flat on both sides when joined.
  8. Use a mitre box and saw to trim the top of the legs to 45 degrees, checking they’re all the same length.
  9. Position the legs together, measure 210mm from the base, then use a combination square to mark across all four legs.
  10. Use a #8 countersinking bit with a drill to make holes on the marks, at the centre of the legs.
  11. Use a 4mm drill bit to make a hole into the centre of the ends of the rails.
  12. Use 40mm screws to attach the rails to the legs, ensuring that the joint on one rail is facing up and the other is facing down.
  13. Apply glue to the joints, position the rails together, clamp and leave to dry.
  14. Use 180-grit abrasive paper to sand all over, rounding the edges and corners slightly for a professional finish.
  15. Tap timber caps into the countersunk screws.
  16. Spray all over with the furniture oil and wipe away excess with a clean cloth.
  17. Add the potted plant!
  • DIY
  • Garden
  • Indoor Plants

Treat yourself to a subscription-Save up to 25%

Plus, your chance to win

Subscribe Now
Treat yourself to a subscription

Treat yourself to a subscription-Save up to 25%

Plus, your chance to win

Subscribe Now
Treat yourself to a subscription

Recommended to you

YOU’LL NEED A WEDGE TO HANG THAT DOOR
Watch 6:32

YOU’LL NEED A WEDGE TO HANG THAT DOOR

{headline}

{headline}

This ultra-chic Kmart hack will add instant style to your home

This ultra-chic Kmart hack will add instant style to your home

Melissa makes colourful colander hanging baskets

Melissa makes colourful colander hanging baskets

How to make a macrame plant hanger

How to make a macrame plant hanger

How to make a terrarium in a jar

How to make a terrarium in a jar

{headline}

{headline}

 This stylish side table doubles as a terrarium

This stylish side table doubles as a terrarium

Adam and Melissa make planters and pots

Adam and Melissa make planters and pots

How to add potted colour to your home

How to add potted colour to your home

{headline}

{headline}

DIY greenhouse: How to build a greenhouse

DIY greenhouse: How to build a greenhouse

5 secrets every green thumb knows

5 secrets every green thumb knows

This is what happens when a plant is bullied for 30 days

This is what happens when a plant is bullied for 30 days

How to make your own eco cleaning products

How to make your own eco cleaning products

How to make a cloud toilet paper holder

How to make a cloud toilet paper holder

How to build a coat rack

How to build a coat rack

How to change a shower head – the easy way

How to change a shower head – the easy way

Bhg
  • About Us
  • Subscribe Today
  • Contact Us
  • Terms and Conditions
  • Privacy Policy
Bhg Magazine Subscribe
  • About Us
  • Subscribe Today
  • Contact Us
  • Terms and Conditions
  • Privacy Policy

Brands

  • All Recipes
  • BHG Shop
  • Girlfriend
  • Home Beautiful
  • New Idea
  • New Idea Food
  • Practical Parenting

Our Network

  • marie claire
  • Beauty Crew
  • Who
  • Women's Weekly Food
  • Bounty Parents
  • That’s Life
  • Perth Now
  • The West Australian
  • 7Plus
  • 7mate
  • 7NEWS
  • 7Sport
  • Sunrise
  • Starts at 60
  • Hard to Find
© 2022 Are Media PTY LTD
All products are independently selected, tested or recommended by our team of experts.If you buy something, we may earn an affiliate commission.
Get more from Better Homes and Gardens

Magazine Subscription Offer

Treat yourself to a subscription-Save up to 25%

Shop This Offer
Treat yourself to a subscription