Gather your supplies
• 600 x 200 x 200mm Hebel block
You'll also need
Handsaw; drill; chisel; dust mask; candle in glass jar; pencil; 28mm speedbor bit; set square; fine-grade sandpaper; tape measure; rubber mallet; rasp; 100mm-dia paint tin; 150mm-dia paint tin
Here's how...
Step 1
With block standing upright, position 100mm-dia tin on top and trace around. Flip block, position 150mm-dia tin on top and trace around (this will be base of your sculpture).
Step 2
Mark 200mm up from base then, star ting from this point, rule a diagonal line that tapers towards centre of base but is no wider than tin marking. Repeat for all base corners.
Step 3
Flip block, then repeat Step 2 to mark top corners.
Step 4
Saw along all marked lines to form a rough shape.
Step 5
Round all sides with a rasp to form shape of sculpture.
Step 6
Using speedbor bit, drill starter hole for candle in bottom half of sculpture. Using mallet and chisel, hack off small bits, then sand smooth. Stand sculpture and put candle inside.